Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Design of an op-amp with single rail

Status
Not open for further replies.
O

otac123

Newbie level 4
Joined
May 8, 2005
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,351
Hi all,
Can anybody help me out with a design methodology for designing a 2stage op-amp with single rail only (ie either of Vdd or Vss). the specs are.......
vdd= 4v ts=100ns cl=3pF output swing is 2v(pp) ad>50db unity gain buffer

can we design an op-amp using ONLY these specs??
plz reply
thank u.
 

U may check this topic , it may contain useful information.

There is a valueable chapter in Razavi analog book for OPAMP design, try to read it.[/url]
 

    O

    otac123

    Points: 2
    Helpful Answer Positive Rating
designing an OpAmp for single or symmetrical power supply is the same. Your methodology does not change.
 

To use a single supply the methodology is to bias at VDD/2 as non-inverting unity gain amplifier for DC and set the required gain and mode inv or non-inv for AC signals.
 

Yes you can design an op-amp using ONLY these specs.
Isn't it good to have loose specs? you can finish your job more easily ^_^
 

desisigning an op amp cct with single rail as ECRAZ said is to bias the non inv. input at 1/2vcc and set the gain through a feedback resistor to the inv. input.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top