DavidZlavan
Junior Member level 2
Hello,
I want to use this LNA -> **broken link removed** for a design. Datasheet shows matching for 0.9GHz but I want to use it at 200MHz.
Which procedure do you use in these cases?
I tried to measure the LNA ADS model without matching and then apply a LC matching similar to the one they show me for 0.9GHz and tried to match that impedance to 50ohms at 200MHz but it didn't work.
Thank you in advance,
I want to use this LNA -> **broken link removed** for a design. Datasheet shows matching for 0.9GHz but I want to use it at 200MHz.
Which procedure do you use in these cases?
I tried to measure the LNA ADS model without matching and then apply a LC matching similar to the one they show me for 0.9GHz and tried to match that impedance to 50ohms at 200MHz but it didn't work.
Thank you in advance,