Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to transfer the data through USB from AT90USB to PC

Status
Not open for further replies.

ldrvasu

Newbie level 1
Joined
Sep 26, 2016
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
18
hi,
i am new to this at90usb1286 micro controller.
i am doing a project (Temperature monitoring module) in the part of my engineering studies which contains
at90usb1286,LM35DT (Temperature sensor) and i am using internal adc (10-Bit) of micro controller
i need to monitor the temperature in a particular room and that temperature has been transfer to PC through UART(RS-232) and USB.
i have done the program for UART and i am able to get the data on PC by using UART.
But, i am unable to program the USB because i don't know how to program this USB.
i searched on internet so many times regarding this USB, every time i got confused.
it is my kindly request that could any one please tell me that
1. How can i program the USB.
2. Before programming the USB let me know that what type of basics i have to learn.
3. If possible, could you tell me the step wise procedure for achieving the data transfer from micro controller to PC(By using USB).

thank you in advance
 

Hi,

did you read AVR272?

Where did you ecounter problems?

Klaus
 

USB HID, VCP, CDC Communication methods.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top