Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

What does the spec on the Relay tells us?

Status
Not open for further replies.
S

sys_eng

Full Member level 4
Joined
Aug 3, 2016
Messages
193
Helped
0
Reputation
2
Reaction score
1
Trophy points
18
Activity points
1,489
relay.jpg

1)12V DC
2)10A/250V AC

why it has both DC and AC?

I see 3 sets of switches

then I see A1 to A2 is a coil.
 

Because the actuating coil is designed to operate from 12 volts dc.

But the electrical contacts are rated to work up to 250 volts ac, and up to 10 amps, or even 400 volts ac at reduced current.

Two very different things.
 

Warpspeed said:
Because the actuating coil is designed to operate from 12 volts dc.

But the electrical contacts are rated to work up to 250 volts ac, and up to 10 amps, or even 400 volts ac at reduced current.

Two very different things.
Click to expand...

So it can work with either DC or AC?
 

Hi,

The coil shows it needs DC (12V); the contacts (1>12/14, 21>22/24, 31>32/34) are supposed to be used with AC. ...If you feel adventurous and use the contacts with DC, the voltage and current must be derated accordingly. Read up on datasheets for - e.g. - single or double pole switches rated for AC and DC to get an idea, the voltages and currents are lower for DC usage.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top