Ragnar22
Member level 1
Hey guys, my plasma TV from minutes to minutes goes black screen. The thing is when I slam it the TV goes back to normal function but after another period of time it goes black again.It's quite annoying.
My toughts: Possible a bad connection somewhere but How can I be sure where?
If anyone has some tips....
some photos that I have taken:
https://drive.google.com/folderview?id=0B-1aydUJ_8fLemNRT2p4b3Fjbms&usp=sharing
- - - Updated - - -
MAIN CAUSES: (From Technical guide)
This may happen when the Main Board is functioning but the X, Y Main Board, Logic Board, or Y Buffer
Boards are not.
- The output voltage of the Main SMPS.
- This may happen when the LVDS cable connecting the Main Board and the Logic Board is disconnected.
These are the main causes according to the technical guide. How do I check the output voltage of the SMPS(Vs and Va)? wich terminals do I check? I can see 2 potentiometer 1 near Va and the other near Vs.
- - - Updated - - -
Just checked Va and Vs with all connectors and they are ok.
My toughts: Possible a bad connection somewhere but How can I be sure where?
If anyone has some tips....
some photos that I have taken:
https://drive.google.com/folderview?id=0B-1aydUJ_8fLemNRT2p4b3Fjbms&usp=sharing
- - - Updated - - -
MAIN CAUSES: (From Technical guide)
This may happen when the Main Board is functioning but the X, Y Main Board, Logic Board, or Y Buffer
Boards are not.
- The output voltage of the Main SMPS.
- This may happen when the LVDS cable connecting the Main Board and the Logic Board is disconnected.
These are the main causes according to the technical guide. How do I check the output voltage of the SMPS(Vs and Va)? wich terminals do I check? I can see 2 potentiometer 1 near Va and the other near Vs.
- - - Updated - - -
Just checked Va and Vs with all connectors and they are ok.
Last edited: