Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
In the circuit you showed the current source is set to generate a current from 10 uA to 100 uA in 10 uA steps. The setting is given directly in the I source where you have written "IBB uA", so any number you set IBB is in uA.
If you prefere, you could also delete uA from the I source (leaving only Idc=IBB) and write in the DC controller:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.