Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

In AHB burst mode, why does master keep on incrementing the Address?

Status
Not open for further replies.
U

u24c02

Advanced Member level 1
Joined
May 8, 2012
Messages
404
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
4,101
In ahb burst mode why master is keep on incrementing Address?

From what I understood, in AHB burst mode, master will only give starting address and slave has to calculate the remaining address. But in the picture below (from AHB specification) shows change in address at HAddress pin for every clock. Am I wrong ? Please correct me if I am.

cbgOs.png
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top