Bjtpower
Full Member level 5
Dear All
I have attached a Block diagram of Cypress to Pic controllers having 10 GPIO and 1 UART connections.
Now i am confusing between the Connections.
Cypress is having High sink current capability at the gpios.
same gpio status going to Pic controller to check the status of the Capsense and accordingly pic will take actions.
I dont know how to connect the cypress outputs to Pic controllers.
Kindly help with the schematics.
Cypress Controller:CY8CMBR3108
Controller not yet select: 10-GPIO,1 UART.
Kindly suggest which controller to used.
Thanks
Marx
I have attached a Block diagram of Cypress to Pic controllers having 10 GPIO and 1 UART connections.
Now i am confusing between the Connections.
Cypress is having High sink current capability at the gpios.
same gpio status going to Pic controller to check the status of the Capsense and accordingly pic will take actions.
I dont know how to connect the cypress outputs to Pic controllers.
Kindly help with the schematics.
Cypress Controller:CY8CMBR3108
Controller not yet select: 10-GPIO,1 UART.
Kindly suggest which controller to used.
Thanks
Marx
Last edited by a moderator: