Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I have two substrate upper and lower,copper is on above substrate and GND is on lower substrate .
I made two cylinders as a probe feed which touches both conductor while simulating i got this problem
[error] Port refinement, process hf3d error: The mesh on port 1 is non-planar. Check the port geometry and verify that the mesh accurately represents the port.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
