Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
oh I see
now I get it. the word 'jumper' was used just because 0 ohm res. are widely used for 'jumper' purposes.
and since for 0ohm, you can't get negative tolerance but only positive values for it, the datasheet prefer to write down 'max res.'.
I checked the datasheet as you said, and I found the 'max res.'.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.