Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
yes that is the basic reson they cost so much. a good auto router saves you a lot of time. but it is a nice habit to manually route the important tracks line diff pairs and so on manualy and then lock them and then route others in auto route mode.
auto placement of components is a bad choise.
hock
first use auto route for look all routing, so you can look line every line betwen component, if no good routing, replace another component.
for finishing route, use manual route all...
Depends on what do you do !
If you use Monoface and DoubleFace,with meny constraints and rules, is very difficult to use it.
Yes manual route,needs more time (apparently), but I never use autoroute for my project !!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.