Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

ADS current and voltage waveform in class-E power amplifier

Status
Not open for further replies.
V

vkschaudhary2010

Newbie level 5
Joined
Dec 30, 2014
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
52
In ADS can you tell me in class-E power amplifier, please refer to circuit at point 'A' in Figure at o/p port, How can I plot current and voltage waveform w.r.t to Frequency?
please find attached figure. aa.JPG.

aa.JPG
 

You cannot obtain voltage and current waveform from this circuit because you're doing s-parameters simulation.
You have to use a nonlinear model for the transistor and you should do either a transient simulation or HB simulation.
 

Thank you sir for ans..
Can u please specify how to use that non-linear model or transient simulation? if possible please show through a figure.
 

vkschaudhary2010 said:
Thank you sir for ans..
Can u please specify how to use that non-linear model or transient simulation? if possible please show through a figure.
Click to expand...
First, you should download the design kit of ATF52189 for ADS ( take care which version you use..) then install it in ADS.( Read the installation guide )
Then it will create a ADS project file and its nonlinear model will be there including package parasitics.After that open a clean schematic page and insert this component from library then make the connections properly ( biasing,load,source,matching etc.) after that do your HB or transient simulations.
 

Thank you BIG BOSS,
can u send me some example for designing of class e power amplifier ads file as i am getting problerm in calculating PAE, gain and power acc. to harmonic balance simulation. Any full example file for PA design.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top