Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

SIM900 and sim holder ESD protection problem

Status
Not open for further replies.
S

Sharagim

Advanced Member level 4
Joined
Feb 6, 2011
Messages
112
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Activity points
2,058
Hi,
According to the datasheet of sim900 I use a SMF05C. before putting it in my circuit it was working properly but after installing SMF05C I cant turn on SIM900 and finally I change the module (seems broken). is there any mistake in my design?
esd.png
 

I think your reset pin is PIN 5 and PIN 2 is VPP you can check the attachment and please follow the all layout consideration
 

Attachments

  • SIM900_Reference_Design_Guide.pdf
    32.2 KB · Views: 59

thx for your reply.
My sim holder is six pin so I follow the layout for 6 pin without SMF05C it was working properly but after soldering the SMF05C, the SIM900 module became very hot and stop working. I was thinking maybe I soldered the SMF05C in wrong direction.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top