dshoter13
Member level 4
Hi everyone.
I already designed and simulated the S-parameters for my circuit with the LNA plus filter. After that, I procceded to the layout design, only with the microstrip lines and pads. After that, I put ports in every spot that contains lumped componentes. When I try to simulate, I get the following error: A conflit between port 8.2 and port 28.2 has been detected.
I created the layout from the schematic.
Any sugestions?
Thanks all for your attention.
Regards.
I already designed and simulated the S-parameters for my circuit with the LNA plus filter. After that, I procceded to the layout design, only with the microstrip lines and pads. After that, I put ports in every spot that contains lumped componentes. When I try to simulate, I get the following error: A conflit between port 8.2 and port 28.2 has been detected.
I created the layout from the schematic.
Any sugestions?
Thanks all for your attention.
Regards.