magnomp
Newbie level 1
I'm designing an arduino shield on Altium.
I first created a reusable arduino shield part whose footprint consists of the pads for the arduino pins.
But when designing a board with it, Altium complains about collision when I put any other part on the board, because it thinks that whole area is meant to be covered by a part (the shield part I created)
Perhaps I'm not being clear, so please look at this:
I first created a reusable arduino shield part whose footprint consists of the pads for the arduino pins.
But when designing a board with it, Altium complains about collision when I put any other part on the board, because it thinks that whole area is meant to be covered by a part (the shield part I created)
Perhaps I'm not being clear, so please look at this:
