Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

using sd card without using FAT

Status
Not open for further replies.
Yes,

You can access the SD Card via SPI without using any file system.
 

Yes, its like a flash memory, but you need to read and write them sector-wise , that is when the sector size is 512 bytes then you need to read and write always blocks of 512 bytes.
 

Using a file system will allow you to insert that card in any windows/linux/android/mac machine and to read/write files, directories aso. Writing raw data, without a file system will make that card usable only for an application which reads raw data from the card and that application must know what and where it is written.
I had few years ago a device which stored all data from a CAN bus onto a sd card in raw format. Then I placed the card in a PC and with an application which works directly with the card (such as hex workshop) I was able to read data from it. But the PC won't see such a card as a valid drive.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top