Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need help to determine Q factor

Status
Not open for further replies.
richloo

richloo

Full Member level 1
Joined
Aug 24, 2004
Messages
95
Helped
9
Reputation
18
Reaction score
4
Trophy points
1,288
Location
Isolated Island
Activity points
748
Hi there, i have designed a Butterworth low pass filter, but i don't know how to measure Q factor from simulation to comfirm my design. Can u guyz help me out?
Thanks~!!!
 

Usually we measure the Q factors only for Band pass and Band Reject filters. But you can get a measure of Q from the transient response and solving for the settling time.

Added after 4 minutes:

Hey you can actually, get the real pole locations from your simulation results using the transfer function analysis(Of course, the poles of the opamp will cause some change). Then you can get the TF and then get Q out of it. This is just a thought, though, I hever never done this myself
 

Thanks Vamsi, it sounds interesting, can u tell me how to setup the circuitry for transfer function (xf) analysis using spectre?
 

Well, you run an ac analysis like you normally do. Then you should add the transfer function analysis to the deck.You should define the input voltage source where you will start measuring and the output node where you will stop measuring. Then the transfer function analysis should give you all the locations of poles and zeroes in between those two points.

You can look into SPECTRE manual for statements for the xf analysis.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top