Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Network analyzer output

Status
Not open for further replies.
G

giangriff88

Newbie level 4
Joined
Jun 18, 2014
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
43
Hallo everyone,

I was wondering how the S parameters are measured.
In particular, if I attach the network analyzer to a variable resistor which varies over frequency let´s say from 50 to 5 Ohm, will I have constant output power at the output of the network analyzer? What I am interested in understanding is what will the voltage drop on the resistor be, and if I can assume it to be constant or not.

Thank you very much
 

Very gray area giangriff88. When measuring the output "power" of a VNA with a power meter, you will get a reasonably constant output across a good 50ohm load. For non-50 ohm loads, your voltage drop across your resistor proportional to the reflected energy. Review a VSWR/Return Loss table.
 

Agreed. And because S-parameter measurement is a measurement of ratios of incident and transmitted or reflected wave, there is no technical requirement for constant incident power.
 

There are a couple of good white papers that can help you

1. Fundamentals of Vector Network Analysis - Primer from Rohde & Schwars: https://www.everythingrf.com/whitepapers/details/447-fundamentals-of-vector-network-analysis-primer

2. Understanding Vector Network Analysis from Anritsu - https://www.everythingrf.com/whitepapers/details/375-understanding-vector-network-analysis

You can also find more white papers on Network Analyzers here - https://www.everythingrf.com/whitepapers/search/?q=network%20analyzer
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top