Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can controller (MCP2515) bit timing cal and wire length

Status
Not open for further replies.
shruv

shruv

Member level 2
Joined
Jun 13, 2013
Messages
47
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
270
1.Does the length of the can wires affect any calculation for bit timing?
2.Can any wires be used for can high & low?
3.How do you calculate the propagation delay?,In the mcp2515 datasheet the values are assumed and no formula is given for the calculation.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top