Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to solve parameters error in the assura

Status
Not open for further replies.
D

devenders

Newbie level 2
Joined
Sep 6, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
14
Hello All,

I have to generate dspf file of register file 64x17.i clear the lvs by using calibre and when i use assura to clear lvs than there is parameter error.
I check the particular transistor length and width and found both parameter correct.
Now, how can i remove this to generate dspf
 

Attachments

  • Screenshot.png
    Screenshot.png
    235.3 KB · Views: 76

If you slid that scroll-bar to the right it should tell you what
discrepancy it thinks it sees. At least, this is true on the
older version of Assura I've been using. This would be your
clue, much more valuable than clueless guessing.
 

dear dick,
initially we are using 5.1 version of cadence but from last month i am using 6.1.5 version of cadence and in this regarding parameter error i had checked length and width of every transistor in particular error block but there were no error and also check the instance library of the transistor this was also same so getting no idea how to remove ,if you have any idea at least around the error, than please help me
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top