Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The bend situation can be easily simulated in 3D simulators like HFSS. If u insists using ADS, remember that the curved parts can only be modeled at the xy plane, since the geometry along the z axis should be uniform.
The bend situation can be easily simulated in 3D simulators like HFSS. If u insists using ADS, remember that the curved parts can only be modeled at the xy plane, since the geometry along the z axis should be uniform.
By taking advantage of the modeling capability of HFSS, it is easy to simulate the bend situation. In particular, there are two features which facilitates this kind of modeling greatly:
1) Sweep - sweep a line to form a sheet, sweep a sheet to form a solid
2) Thicken - a sheet can be thickened to form a solid with an assigned thickness
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
