Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

How to get underpass and over pass for MSIND and MSSPLR_MDS in Agilent ADS

Status
Not open for further replies.
R

raju_kambar

Full Member level 3
Joined
Jun 19, 2013
Messages
153
Helped
5
Reputation
10
Reaction score
5
Trophy points
18
Location
Earth
Activity points
1,404
Dear Sir,
I have connected printed microstrip spiral inductor MSIND or MSSPLR_MDS to microwave circuit. How to get under pass and over pass for MSIND and MSSPLR_MDS in ADS. I want to generate the layout for this connected MSIND or MSSPLR_MDS ,later to get the fabrication. Can you help me anybody.

 

Choose a proper 2 metal layers substrate ( or create) and assign the metal layers onto it..
 
Dear Sir,
Is it sufficient by choosing the 2 metal layer substrate and assign the metal onto it for getting generation of overpass and underpass spiral inductor.
 

raju_kambar said:
Dear Sir,
Is it sufficient by choosing the 2 metal layer substrate and assign the metal onto it for getting generation of overpass and underpass spiral inductor.
Click to expand...

Should be..
2 Metal layer will give you at least 3 dielectric layer including air/space.If you choose first metal layer for spiral, you can use second metal layer for overpass or vice versa..
If you choose the first metal layer for underpass, second layer will be for spiral.If you organize dielectric layers, you can obtain your spiral inductor with proper dielectri and metalic layers.
 
BigBoss Sir,
Thank you for your kind help. I will try as you said.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top