nannapaneni
Junior Member level 3
I am doing corner simulation using spectre decks in 40nm technology.
To change process I am using altergroup statement as below:
alter2 altergroup{
include "modelfile"
}
Now it was showing error:
ERROR (SFE-700):
"modelfile"
3214: altergroup statements cannot be specified within altergroups.
Help in getting out of this issue.
Thanks for reading
-Nannapaneni
To change process I am using altergroup statement as below:
alter2 altergroup{
include "modelfile"
}
Now it was showing error:
ERROR (SFE-700):
"modelfile"
3214: altergroup statements cannot be specified within altergroups.
Help in getting out of this issue.
Thanks for reading
-Nannapaneni