Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] how to use topology?

Status
Not open for further replies.
D

danismith

Member level 2
Joined
May 29, 2013
Messages
47
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,584
hai friends,
Am just a learner in allegro 16.3,i just know how to route but not professionally.my design is looking horrible.can any one explain me how to use the topological routing like chain,daisy,star,etc for a common board.
 

Manual route the design. The topology depends on the type of signal, its speed (rise time), and for most simple board just routing should suffice.
 

There is no specific option to route normal and topology routing..it is same..it depends on how u route the signals..
 

routing is laying down the tracks, the topology you use depends on the signal and how many pins it goes to. You would use daisy chain for I2C or similar, parallel for another type of signal...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top