Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Trying to run a circuit with 74123 one shot

Status
Not open for further replies.
S

STINGERX

Junior Member level 3
Joined
May 14, 2013
Messages
25
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,465
i’m trying to run this circuit but i don’t realy understand what is the problem?
as you can see in the attached image this is how i connected the circuit into an integrator on pspice.
oneshot.jpg
 

crutschow said:
Since you didn't say what your problem is, I don't understand the problem either. :???:
Click to expand...

sorry

i want to design a circuit that summarize (with the integrator) the pulses from a photodiode, to do this i need to use one shot circuit but I don't really understand how to connect it to the integrator and from the pulse generator
pspice shows me errors that say's there are floating connections

any suggestions?
 

What is the purpose of the one-shot in the circuit? Is it to reset the integrator after integrating the pulses?

If Pspice says there are floating nodes then you need to determine where they are. I don't offhand see any in your schematic.
 

Mind you, a one shot with a 1pF timing capacitor which feeds a 741 is asking for trouble. I think a somewhat faster op-amp might be a good idea.

Brian.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top