Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
I am designing a folded cascode opamp with a single-ended output and that has
both NMOS and PMOS input differential stages (for wide input common mode range).
All the circuits I see, however, have a differential output. Is the bottom design
a correct implementation of a single-ended output?
Is there a mistake in the schematic?
The MOSFET in the top right corner of the picture has it's gate connected to the output, and the source and drain connected to Vdd. :-?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.