Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

DDR3 rank and number of chips

Status
Not open for further replies.
S

syedshan

Advanced Member level 1
Joined
Feb 27, 2012
Messages
463
Helped
27
Reputation
54
Reaction score
26
Trophy points
1,308
Location
Jeonju, South Korea
Activity points
5,134
Dear all,

I am using the MT41J256M16RE-15EIT:D DDR3, but I cannot know how many ranks and how many chips / DDR or chips/ rank are there
from the data sheet. What I have calculated my self is that it has only one chipe which has 8 banks and that chip itself is 4GB (size of DDR3).

Is it possible to have only 1 rank and 1 chip in DDR3

I have also attached the data sheet if someone wants to refer to answerView attachment MT41J256M16RE-15EITD.pdf
 

Hi What is ur memory requirement?Now days single chips are available up to 8Gb..Attached data sheet is a single chip which support 4Gb memory..
 

Thank you for your question..

I have several questions. I hope you answer the one you can.

1. Can we make 1GB memory out of it with MIG design.
2. Is the User Interface in the DDR3 controller the FIFO design. I actually want to save data for good (of course unless power is ON). I dont want to
use the FIFO design.

others as well. but later :smile:

Bests,
Shan
 

Yes we can make.If you are planing to use 4Gb chip and 32 bit data bus then u have to use two such devices...before proceeding in to the actual design u can try generating core for DDR3 using MIG.

Also check weather the selected FPGA supports DDR3 or not...
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top