Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
The only way is to communicate with it over i2c bus. Use a microcontroller in i2c master mode.
See the datasheet:
The simplest functional check once you have i2c connected would be to turn on the square wave output on pin 7 of the DS1307 and check that pin for a signal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
