Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

how to add via in PADS Layout for return current path?

Status
Not open for further replies.
V

Veronika

Member level 2
Joined
Mar 30, 2012
Messages
51
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,651
1. How can I add separate via in PADS Layout software for return current path for signal trace, which changes the layer? I know only how to add via while routing.
2. As I understood, via is used for return current path when both reference planes are GND. But what should I do when the reference plane is changed from GND to Power plane?

Thank you in advance!
 

Maybe look at adding a bypass cap connected between power and ground placed near this via
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top