Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
My issues is the backlights are receiving improper voltage and will only light up halfway. If I ground one of the HV lines, that CCFL will light up normally, but if I ground both off the same transformer coil, the backlights will come on briefly then all will turn off. If I short a set of HV lines on the same coil, the whole backlight will work properly til the TV shuts itself off after a couple of seconds. I think I may either have a grounding issue or the "T803" transformer has partially blown.
Not sure how I'd repair the transformer if so, but I'd love to try
Can you take a photo of the other side of the board. I got problems with this board coz some of the surface mounted parts are burned up. This are the parts that i need to identify. R830,R831,R836 and N801. Thanks in advance!!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
