Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Loading program with 80x51 family on ACEX1K

Status
Not open for further replies.
S

syntronik

Newbie level 5
Joined
Sep 4, 2004
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
86
Migrations to ACEX1K

Hello
I have worked a long time whith MAX7000S family, now I need to change to ACEX1K, I have see the possibility of use i/o voltage qt 5 volts, and I whant to load the program, not whith serial eeprom but whith 80x51 family, somebody have some applycations for help me, the manuals not have more informations, only somes article and not more.
Regards
Maurizio
clmelettronica.com
 

Re: Migrations to ACEX1K

Do u have 8051 on ur board ??? or is there a chance of change in ur logic later ??
i think going with serial Eprom is better... u can go with EPC2 series also... or download directly from byteblaster or master blaster..
 

Migrations to ACEX1K

I have a 80c32 on board, but the memory of EPK50-208 is to large, better use EPC16 exepencive but OK, I have also found the documentation on Altera Site. You work whith 80X51 family? if yes we can interchange somes suggestions
regards
Maurizio
 

Re: Migrations to ACEX1K

No i never done that... but was planning to do that....
I used PS config and JTAG config to load my program..
what about u ?
 

Migrations to ACEX1K

I use ByteBlasterMV, I just finish to nigth to develop in verilog, the control position, for 4 motor ,
and I have select the SPP configuration
Regards
Maurizio
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top