Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Need information about USB driver and windriver

Status
Not open for further replies.
M

mohammadreza77

Newbie level 2
Joined
Mar 3, 2004
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
21
+cypress +usb driver +fx2

hi,
i have read sth about USB and microcontroller and i want to do some simple example in USB micro. and also designing deriver for USB by windriver(jungo).well i hope sbd will help me in finding more about USB driver and windriver first and then USB micro.
thanks.
this for windriver.
https://www.jungo.com
 

cy7c68013 driver

it s more cheap and easy to use the driver that give the manufactor (cypress motorola..). You can transmit data.
build a driver only if you have a very special thing to do..
jqp 8O 8O
 

USB driver

Look at Numega Driver Studio also...
 

Re: USB driver

Hi mohammadreza77

Which one uC you want to use? If FX2 from Cypress then you don't need expensive windriver. You can download sources of Control Panel for FX2 from Cypresses web site. After studing this code you shouldn't have any problems to use it in your application.

Best reg
 

Re: USB driver

hi
you can download a very good book from edaborad
about it
bye :eek:
 

Re: USB driver

You can see www.cypress.com and use ez-usb fx2(CY7c68013) a usb2 controller.Jungo windriver7.0 will help you trough driver and firmware both. At first you must design an simple project and you must pay attention to desing it. It is very important.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top