Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Error with Drill in Allegro

Status
Not open for further replies.
S

SagSag

Full Member level 1
Joined
Feb 11, 2006
Messages
99
Helped
8
Reputation
16
Reaction score
4
Trophy points
1,288
Activity points
1,829
Hello all

I'm trying to create the artwork files in allegro.
but the drill file has a problem. it gives me the following error:

Shape at (75.00 283.00) contains void at (75.00 283.00)
which touches another shape.
You need to manually resolve this problem.

this is a GND layer and the shape is the GND rectangle, I don't understand what it wants from me
I attached a small picture showing the area the SW is pointing.
47_1320268832.jpg

anyone know how to fix this?

thanks
 

hi,

i thing u have two shapes in that location please delete one.
 

Check for any possible text/ legend entry at that coordinate. This may be present in drill layer by mistake. I recently had a nightmare problem with a similar issue. To resolve such error, select only the Via drill, delete it and add a new one without disturbing the routed trace..
 

move the Shape in to some other location using 'ix' command. ( say ix 100)
then delete all voids using 'shape--> manual voids--> delete ( by draaging and selecting the entitr shape) .
Now move back the shape in to actaul position using 'ix' command ( ix -100)
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top