Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Electronics project regarding full bridge Inverter with MOSFET andIR2110

Status
Not open for further replies.
C

ch wazir

Full Member level 3
Joined
Oct 8, 2011
Messages
156
Helped
23
Reputation
46
Reaction score
20
Trophy points
1,298
Location
lahore
Activity points
2,114
I hve read the thread regarding Full Bridge Inverter with MOSFET and IR2110 gate driver but unable to understand that how the 12 Volts (single Batter) can be raised to 120/220 Volts without step up transformer.Any one should explain it. Thanks, Ch wazir
 

It is not possible to step up voltage from 12 volts to 120/220 volts. I think you missed the output part of the design. Either it is directly connected to 12 volts /220 volts transformer or the voltage from 12 volts is raised quite high (like 400~600 volts) and then controlled to the load with with transistors. See the attached Circuit just for your reference.
12v-220v-invertor-ferit-trafo.gif
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top