Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Full-Bridge SMPS on double sided PCB?

Status
Not open for further replies.
G

grizedale

Advanced Member level 3
Joined
Jun 13, 2011
Messages
838
Helped
17
Reputation
34
Reaction score
17
Trophy points
1,298
Activity points
8,804
Hello,

Is it recomended to do a full-bridge SMPS (330W; Vion = 90-265VAC) with charge-pump high-side gate drivers on a double -sided PCB?

eg using two NCP5181 gate driver IC's.......
https://www.onsemi.com/pub_link/Collateral/NCP5181-D.PDF

..its just that its four gate drive signals to route....and i wonder if this makes some go to 4 layer PCB?
 

it would depend upon on overall size of PCB, I think if you are able to route (with necessary shielding or physical separation) i think 2 layer be OK.
 
convert the pcb to single sided
double layer pcb's are horrible from servicing point of view,
i have not been able to remove a SMPS transformer from a double sided board as yet
 
I think if you can separate between High voltage and low voltage for noise and other and shielding , thats very good to design multi-layer board as atripathi said.
 
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top