Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
heck if this translator comes free of cost with mentor tools, or you need to pay for that. I have used Orcad to Pads Logic & DXDesigner converter in past. They work fine. But a fine check of converted schematics is highly suggested because there used to be some errors in translations of certain schematic symbol attributes in the version of translator I used (way back in 05).
---------- Post added at 14:38 ---------- Previous post was at 14:36 ----------
Second question- best way to add fiducials is to add dummy schematic parts in schematics, and label them as fiducials. They will not carry any electrical connection, but will be associated with a pad stack that will sit on the PCB. This way your DRC errors will also be less
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
