Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help with DAC topology selection

Status
Not open for further replies.
Q

qslazio

Full Member level 3
Joined
May 23, 2004
Messages
175
Helped
18
Reputation
36
Reaction score
7
Trophy points
1,298
Activity points
1,420
Folks,

I'd like to choose a DAC topology to have below spec:
1. 100KHz sample rate
2. 10 bit
3. minimum DNL but much relaxed requirements on INL


Can anyone suggest a topology to have smallest area?

Thanks,
SQ
 

Generally it is depends on technology,- e.g. are high resistance or double poly (or MIM, with Cox ~1fF/um^2) capacitance options available. Typically switched capacitors DAC can be attractive: using 0.1pF unit capacitor total matrix (~100pF) with switches can be as small as 0.2 sq.mm. Of course need also output buffer OA, bias and control circuitry. All of this auxiliary blocks strongly depend on technology, specs. But in any case you can have below 0.5 sq.mm.
 

resistor-based DAC might be OK too.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top