Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Is it necessary to measure 1dB power compression point for a Class E power amp?

Status
Not open for further replies.
S

sharethewell

Member level 5
Joined
Apr 17, 2010
Messages
91
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
2,078
I am simulating a Class E RF Power Amplifier in Cadence Virtuoso Spectre. I am just wondering that if it is normal to measure 1dB power compression point of a non linear (switching) power amp like Class E? Why?

If yes, then I am not sure if I set up the PSS analysis right. Could you please check it right below? (433MHz is the operating frequency of the PA)

PSS setup.png

Please check the direct plot form as well right below. Thanks.
Direct Plot Form.PNG
 
Last edited:

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top