Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

import MOS level3 Model in ADS

Status
Not open for further replies.
P

perado

Full Member level 2
Joined
May 28, 2010
Messages
127
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,298
Activity points
2,134
I want to import the MOS level3 Model transistor to ADS and use transistors with this model, the level3 model is shown at picture and also the model parameters in ADS, but some parameters in level3 Model is unknown and one parameter that I show with red rectangular isnt in ADS model , now help me please what I should do?

 

cant anyone help me ?
 

Avant's True Hspice Device Models Reference reports WD in the LEVEL 3 IDS Empirical Model as "Lateral diffusion into channel width from bulk", s. p. 9-21 (or 587) from the following PDF:

View attachment Avant_True-Hspice_Device_Models_Reference Manual_2001.4.pdf

As ADS doesn't recognize this parameter, I'd suggest to omit it, or, for small MOSFETs, take Weff = W-2WD, s. e.g. p. 8-20 (472) or 8-101 (553) in the PDF.
 
  • Like
Reactions: perado

    P

    perado

    Points: 2
    Helpful Answer Positive Rating
thanks erikl
I use 0.5um technology
i read the parts of pdf you suggest to me and see HSpice level 3 model parameters but some parameters of ADS level 3 model are not in it, what value I use for these parameters for simulation?
 

some parameters like Tt , Af ...
 

Simply omit them if you don't have their values. ADS uses default values for them, see , p. 8-66 ff. (resp. 240 ff. in the PDF).
The transit time Tt is only necessary for the parasitic anti-diode; default 0.
Af is the flicker noise exponent (default 1).
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top