Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

L298 and stepper motor

Status
Not open for further replies.
A

akoangsimula

Member level 5
Joined
Aug 3, 2010
Messages
84
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,288
Location
Batangas - Malvar
Activity points
1,763
hi guys,,,
can u give some ideas in the connection of L298 and a stepper motor.. and it can be possible that a max233 can support the rotation of the stepper?
 

akoangsimula said:
hi guys,,,
can u give some ideas in the connection of L298 and a stepper motor
Click to expand...
For an L298, pin 2 and 3 to one phase coil, and pin 13 and 14 to the other phase coil.

akoangsimula said:
.. and it can be possible that a max233 can support the rotation of the stepper?
Click to expand...
I cannot see any reason why not. Is it very important that you use only one max233 chip?
 

driving a stepper: **broken link removed**

max232 is used in Uart applications not in stepper control, you need to include a microconroller in the middle of both (max232 and l298)
 

how would be an L298 and max233 be interconnected? im currently dealing with human motion detection in matlab..is it possible that i will not use microcontroller anymore?
thank you

---------- Post added at 16:16 ---------- Previous post was at 16:14 ----------

im planning to use the max233 in RS232...and im thinking to connect the L298 together with the max233..is it possible..thank you
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top