Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

cantileve beam design of series switch using Coventor

Status
Not open for further replies.
P

pratik bheley

Newbie level 4
Joined
Feb 17, 2010
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
india
Activity points
1,328
facing problem in MEMmech simulation please help
hello sir,
i am facing problem MEMmech simulation of coventor as (help mannual for beam design is for shunt switch) & iam designing series switch
problem-surface BC (in fix -fix beam type) their are two anchor 1 & 2 (as mentioned in MASTERHELP HELP MANNUAL)
but in our case their is only one anchor,so in surface BCS environment in set1 fix type Fix All there is patch1 i have mentioed only one anchor1& patch2 =none,SET 2 FIX TYPE-LOAD PATCH ->patch 1-top beam . but still it failed to simulated
i have change combination to and1 to and/ or but still it couldn"t simulated please help
thank you
pratik
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top