Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

some problem about the DLX instruction set and the corresponding architecture

Status
Not open for further replies.
Z

zhengyudennis

Newbie level 4
Joined
Nov 11, 2010
Messages
7
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,347
Hello,
when I learning the DLX instruction set and its corresponding architecture, there are a mux in ID stage to select the one from three candidate numbers to calculate the new address. Two of them are immediate numbers, to which I find the corresponding instruction. However, the last candidate is from a register. I have searched through the whole DLX instructions, but failed to find a instruction that uses the number from the register to calculate the address.
what is the use of third candidate. Can anyone give me some explanation? Thank very much!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top