Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

[SOLVED] SAR calculation in CST microwave studio

Status
Not open for further replies.
D

dazhiruoyu

Newbie level 2
Joined
Jul 10, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,292
I am using CST to simulate microwave heating response of tissue using coax cable. I assign density to materials in order to calculate SAR. But the transient solver will stop at Transient Analysis, Pass 1, Raster=1.000, and never respond.
When I restart CST, I could see the simulation results.

But if I set the density of materials to 0, the simulation runs pretty fast. But I can't calculate SAR.

Anyone know why does this happen?

Thanks!
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top