Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Clamper Turns into Voltage doubler when no load is attached

Status
Not open for further replies.
T

tkcmd

Newbie level 4
Joined
May 26, 2001
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
70
I made this little power supply but i have a problem wich i cant explain

**broken link removed**

When i make it like in the schematic my voltage between posive and ground terminal gets 48V (2x24V) and between negative and ground only -1V.
As soon as i add a 10k Ohm between the positive and ground terminal i get +24 V between + and ground and -24V between - and ground as it is supposed to be
Can someone explain me how it comes then when no load is attached the circuit acts as a voltage doubler ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top