losties
Newbie level 2
anyway i bought this Ultrasonic Proximity Detector Kit B214, i fully built it and tested it.
image ---> **broken link removed**
i've extendid the wires from the kit just like that one to make the sensor more flexible to move around, but what i want is to hook it up to a oscilloscope but i dont know how too with this circuit here is the schematic for it:
**broken link removed**
i want to know which one is transmitting and which one is receiving, so when i can measure the amplitude of the receiver once its hooked onto the oscilloscope. that will give me an indication of the sort of angle which ill be dealing with.
Any advise would be good thank you.
more layout of the kit.
parts for the circuits:
**broken link removed**
Actual set up of the circuit on PCB board:
**broken link removed**
image ---> **broken link removed**
i've extendid the wires from the kit just like that one to make the sensor more flexible to move around, but what i want is to hook it up to a oscilloscope but i dont know how too with this circuit here is the schematic for it:
**broken link removed**
i want to know which one is transmitting and which one is receiving, so when i can measure the amplitude of the receiver once its hooked onto the oscilloscope. that will give me an indication of the sort of angle which ill be dealing with.
Any advise would be good thank you.
more layout of the kit.
parts for the circuits:
**broken link removed**
Actual set up of the circuit on PCB board:
**broken link removed**
