Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Monte Carlo analysis for lumped RF filter

Status
Not open for further replies.
L

LNA

Member level 3
Joined
Nov 19, 2009
Messages
64
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Activity points
1,735
I'm designing a lumped RF BP filter. ADS can synthesis the circuit easily with ideal LCs. Then I wnat to see the yield with different components tolerance in Monte Carlo analysis.

Question is, How can I setup ADS to directly calculate result of BP f0, so I can set f0 as a yield goal in Monte Carlo? I know ADS can do it the indirectly in dataset but I don't know how to loop this result back into the circuit window.

I hope you could understand the question. Thanks.
 

Thanks so much. Very helpful.
 

In filter synthesis block, there is a "sensitivity analysis" tab, if use this tab, ads will give you the sensivity or in otherwords the statistical filter response causing by component variations.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top