Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Connecting IMUKit and PC over USB/Serial port

Status
Not open for further replies.
Maxwell077

Maxwell077

Advanced Member level 4
Joined
Sep 18, 2009
Messages
115
Helped
15
Reputation
32
Reaction score
11
Trophy points
1,298
Location
Puerto Rico
Activity points
2,029
IMUKit Animation

Dear friends,

I have an IMUKit that has 6D DOF gyro&accelometer sensor kit.
Please check **broken link removed**

I would like to connect IMUKit and PC over USB or Serial Port and debug it. Is there any animation programs on PC that animates the movements of kit? Or they are dependent kit by kit.
What's the way of doing my purpose? Any suggestions are appriciated.

Regards
Ilgaz
 

Re: IMUKit Animation

Hi Ilgaz,

Since outputs of IMUKit are analog. you'll need additional hardware to digitize the analog inputs and present them to PC. There's a couple of alternative routes you could take:

* add microcontroller that has A/D channels on one end, USB or UART on the oother end.
* add a USB data acquisition (DAQ) device. I usually use USB-6008 made by National Instruments. There are many others.

Consider also Bluetooth as another option in addition to USB and RS232.

- Nick

P.S. Here's another good place to ask sensor-related questions: **broken link removed**
 

    Maxwell077

    Maxwell077

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top