Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

working with AT91SAM7S256 and using Iar embedded workbench

Status
Not open for further replies.
P

Phong.dq

Newbie level 4
Joined
Jan 28, 2010
Messages
5
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
VietNam
Activity points
1,309
Hello everyone.

I have a project using IAR embedded workbench and ARM AT91SAM7S256. I built my project successful. I can using "download and debug" to run my program in my board. but, when I restart my board or run start my board without debug, it didn't work. What do I have to do with IAR option?
 

hi
i was tested with ewarm 5.41 and it don't work after restart and chip don't work after program by sam-ba.
i trace source code and find out this problem is in startup code.
this problem occured exactly after low_level_init and in asm command "b main".
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top