Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Calibre LVS error: exit code 4 in pad layout

Status
Not open for further replies.
S

shakeel_qureshi

Newbie level 3
Joined
Jul 19, 2005
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,300
Calibre LVS error: exit code 4 in pad layout:
--------------------------------------------------
I have a sheet of metal connected with a pin in layout and a pin in schematic. When I run Calibre LVS, I get error "exit code 4" and it says that the layout and schematic are empty.

Any ideas to solve this?

PS: calibre outputs attached!
 

1. have u specifed the top subckt name in calibre for pre and post designs
i have faced this issue that sometimes i have a pll layout and i put top as adc ...
calibre will read post/pre designs as empty in that case
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top