Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Can anyone let me know the connection of INA122 to ADS7861

Status
Not open for further replies.
K

Ken750

Newbie level 3
Joined
Nov 3, 2009
Messages
3
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,298
Hi, everybody. I need to connect an instrument amp to ADC. The instrument amp i am using is INA122 where its has one output voltage while the ADC i need to use is ADS7861 which has dual inputs..... The ADS7861 has Ao, A1 , Bo and B1 input.... i am not sure how to connect the INA122 to these inputs....

Sorry for my poor english and i hope you guys can understand.....

Thank you for help in advanced.
 

A scheme for the connection of a single-ended signal source is provided in the ADS7861 datasheet: Connect the - input to REFout and the + input to the source, referenced to REFout. With an instrumentation amplifier, connecting the Ref pin also to REFout would achieve this. As another point, you should limit the ADC input voltage to the allowed 0..+5V range. Assuming a +/- 5V INA122 supply, a schottky clamp to GND would be sufficient. In case of a +5V single supply, no clamp circuit is needed.
 

    K

    Ken750

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top